Fairfield Connecticut Building Expert Directory

Puerto Rico Grid Restoration Plagued by Historic Problems, New Challenges

November 08, 2017 — Pam Radtke Russell - Engineering News-Record
While the federal government is helping to restore power to Puerto Rico as fast as it can, that work is being made more difficult due to the dilapidated, pre-Hurricane Maria state of the grid and because long-term, post-disaster power restoration is typically not the federal government's mission. Read the court decision
Read the full story...
Reprinted courtesy of Pam Radtke Russell, ENR
Ms. Russell may be contacted at Russellp@bnpmedia.com

Court of Appeal Opens Pandora’s Box on Definition of “Contractor” for Forum Selection Clauses

October 02, 2015 — David A. Harris & Abigail E. Lighthart – Haight Brown & Bonesteel LLP
In Vita Planning and Landscape Architecture, Inc. v. HKS Architects, Inc. (“Vita Planning”), the First Appellate District held California’s Code of Civil Procedure section 410.42 (“Section 410.42”) which prohibits an out-of-state contractor from requiring a California subcontractor to litigate disputes in a state other than California, applies not only to traditional “contractors” and “subcontractors” but also to design professionals and architects. In Vita Planning, a dispute arose when HKS, a Texas based architectural firm, refused to pay Vita Planning and Architecture (“Vita”), a landscape design firm, for work on a luxury hotel in Mammoth Lakes, California (“Project”). HKS contended it was not required to pay Vita until it was paid by the owner of the Project, and any claims regarding the work needed to be filed in Texas pursuant to a forum selection clause contained in a Prime Contract between HKS and the Owner. The forum clause was “incorporated by reference” into an unsigned “standard form” agreement between HKS and Vita. Despite the forum clause, Vita filed a Complaint against HKS in Marin County Superior Court. Reprinted courtesy of Abigail E. Lighthart, Haight Brown & Bonesteel LLP and David A. Harris, Haight Brown & Bonesteel LLP Mr. Harris may be contacted at dharris@hbblaw.com Ms. Lighthart may be contacted at alighthart@hbblaw.com Read the court decision
Read the full story...
Reprinted courtesy of

Housing Starts in U.S. Slumped More Than Forecast in March

April 20, 2016 — Sho Chandra – Bloomberg
New-home construction in the U.S. slumped more than projected in March, reflecting a broad-based retreat that showed the industry lost momentum heading into the busiest time of year. Residential starts decreased 8.8 percent to a 1.09 million annualized rate that was the lowest since October and weaker than any forecast of economists surveyed by Bloomberg, Commerce Department data showed Tuesday in Washington. Permits, a proxy for future construction, also dropped. Read the court decision
Read the full story...
Reprinted courtesy of Sho Chandra, Bloomberg

Revisiting OSHA’s Controlling Employer Policy

December 21, 2017 — Wally Zimolong - Zimolong LLC
The United States Court of Appeals for the 5th Circuit has been asked to review OSHA’s twenty year old “controlling employer” policy. As many contractors are surprised to learn, under OSHA’s controlling employer policy, you can be given an OSHA citation even when your own employee is not exposed to the alleged hazard. A. The Controlling Employer Policy OSHA’s current controlling employer policy has been effective since 1999. That policy applies to multi-employer worksites, which means virtually all construction sites. Under the policy, OSHA can cite the creating, exposing, correcting, or controlling employer. A creating employer is one who creates the hazard to which workers are exposed. The exposing employer is one who permits his employees to be exposed to the hazard, whether it created the hazard or not. The correcting employer is one who is responsible with correcting known hazards. Finally, the controlling employer is one “who has general supervisory authority over the worksite, including the power to correct safety and health violations itself or require others to correct them.” Most general contractors and CM’s are controlling employers. Under OSHA’s policy, a contractor’s OSHA safety obligations hinges on whether it is a creating, exposing, correcting, or controlling employer. The creating, exposing, and correcting contractors obligations are fairly straightforward. However, the controlling contractors obligations are more nuisanced. Read the court decision
Read the full story...
Reprinted courtesy of Wally Zimolong, Zimolong LLC
Mr. Zimolong may be contacted at wally@zimolonglaw.com

Tall Mass Timber Buildings Now Possible Under 2021 IBC Code Changes

February 03, 2020 — Kenneth Bland - Construction Executive
The International Code Council (ICC) has approved 17 changes to the 2021 editions of the International Building Code (IBC) and International Fire Code, allowing for mass timber buildings up to 18 stories. With the addition of three new mass timber construction types (Type IV-A, IV-B, and IV-C), this is the first time in the history of the modern building code that significantly new construction types have been added to the code. Building Materials The primary building material that makes tall mass timber (TMT) buildings possible is cross-laminated timber (CLT). CLT is manufactured from dimension lumber (nominal 2x lumber) laid side-by-side or mass plywood panels of a specified width. Laminations of lumber are typically laid perpendicular to each other to form panels of various thicknesses that are bonded together using heat resistant adhesives that cure in large hydraulic presses. CLT commonly consists of an odd number of laminations. These solid wood panels can be anywhere from 6 inches to 20 inches nominal thickness and 60 feet long. Typical CLT panels will be 6 inches to 14 inches nominal thickness. The panels are fabricated off site, transported onto the construction site and assembled in a manner that is efficient and remarkably fast. CLT panels can be used as floor, wall, or roof building elements supported by glued-laminated beams and columns. Reprinted courtesy of Kenneth Bland, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

Approaches to Managing Job Site Inventory

January 04, 2018 — Jessica Stark - Construction Informer
Originally Published by CDJ on August 30, 2017 There is no question that organization on the job site can mean the difference between efficient performance and costly errors. A simple mistake can cost a company thousands, which is why details are carefully articulated and supervisors become better scrutinizers than magazine editors. But for some reason, many companies don’t consider managing job site inventory under this same attentive category, or perhaps they don’t know about the technology available to help them do it. For contractors, keeping track of every piece of material and equipment lowers losses and keeps crews busy. This is especially true for contractors in the trades who often have specialized equipment in inventory such as power supplies, HVAC “smart energy” components or inspection equipment. Once everything is accounted for, the possibility of loss is decreased and there’s a chance to evaluate the use of all materials and equipment. This can show the efficiency of allotted resources. Is there enough equipment on the site to get tasks completed? Is there a need for more? Less? Having excess equipment can sometimes prepare a crew for problem scenarios. But it can also mean the construction company is overpaying for unneeded resources. However, the only way to know is by effectively managing job site inventory. That includes all equipment and materials Read the court decision
Read the full story...
Reprinted courtesy of Jessica Stark, Construction Informer

Colorado Senate Voted to Kill One of Three Construction Defect Bills

May 05, 2014 — Beverley BevenFlorez-CDJ STAFF
The Denver Business Journal reported that the Colorado Senate Appropriations Committee voted 5-2 to kill SB 219, one of the three construction defect bills introduced by Sen. Jessie Ulibarri, D-Commerce City. SB 219 “would have given the divisions of housing, insurance and law a combined $150,000 to collect data that would shine light on the reasons for the current shortage of owner-occupied affordable housing.” However, the two other construction defect related bills are still alive. SB 216 “would offer financial incentives for building condos worth less than $500,000 and SB 220, would make it more difficult for condo owners to file a class-action lawsuit regarding alleged defects.” Read the court decision
Read the full story...
Reprinted courtesy of

American Arbitration Association Revises Construction Industry Rules and Mediation Procedures

April 08, 2024 — Dennis Cavanaugh & Larry Grijalva - Construction Law Zone
The American Arbitration Association (AAA), one of the longest-standing and experienced alternative dispute resolution (ADR) administrators, has unveiled a significant update to its Construction Industry Rules and Mediation procedures. This update, last revised in 2015, became effective March 1, 2024. Changes to the AAA Construction Industry Rules are significant as these rules are incorporated by default in American Institute of Architects standard construction forms, which are widely used in the industry. Advancements in remote access technology drive a substantial number of new changes. Others are designed to streamline the arbitrator appointment process and certain prehearing procedures and to make arbitration more cost-efficient by enhancing the arbitrator’s case management authority. Some of the more notable changes are: Fast Track F-1: The limit for cases eligible for AAA’s Fast Track Procedures has been increased from $100,000 to $150,000 so long as no claim or counterclaim exceeds that amount. Reprinted courtesy of Dennis Cavanaugh, Robinson & Cole and Larry Grijalva, Robinson & Cole Mr. Cavanaugh may be contacted at dcavanaugh@rc.com Mr. Grijalva may be contacted at lgrijalva@rc.com Read the court decision
Read the full story...
Reprinted courtesy of

FAIRFIELD CONNECTICUT BUILDING EXPERT DIRECTORY AND CAPABILITIES